Enrolling a ZS300 Sensor
Enrolling a ZS300 Sensor

Enrolling a ZS300 Sensor

The following are required to enroll a ZS300 Sensor in the Zebra Developer Portal.
  • ZB200 Bridge or an Android v8.1 or later mobile device running the Android Sensory Discovery Service
  • Access to an ethernet port and ethernet cable.
  • One or more ZS300 Sensors.
  • A Client Key
  1. Navigate to the Zebra Developer Portal at developer.zebra.com.
  2. Login to the Portal.
  3. Click
    Authorize
    and enter your Client Key.
  4. Click
    Close
    .
  5. Expand the POST/devices/sensor-enrollments method screen.
  6. Click
    Try It Out
    .
  7. Enter the serial number located on the front of the ZS300 Sensor in the JSON body.
  8. Click
    Execute
    . If successful, an HTTP Status Code 200 displays, the response body is an empty JSON body, and the device is scheduled to be enrolled.
  9. Hold down the button on the front of the Sensor until the amber LED blinks. After one or two minutes the device is enrolled.
  10. Proceed with Listing the Sensors.