Mounting the Device
Mounting the Device

Mounting the Device

Each configuration of the device requires the appropriate mounting bracket to mount the device to a wall or other flat surface. The diameter of the holes for the wall screws is 5.8 mm (0.228 in.).
  1. Determine the CC600 or CC6000 mounting location.
  2. Secure the mounting plate to the wall using the screws provided (three screws for the CC600 plate and four screws for the CC6000).
    Attaching the CC600 Bracket To Wall
    Attaching the CC600 Bracket To Wall
    Attaching the CC6000 Bracket To Wall
    Attaching the CC6000 Bracket To Wall
    1
    To wall
  3. Insert the four shoulder screws, also provided, into the mounting holes in the back of the device.
    Inserting Shoulder Screws
    Inserting Shoulder ScrewsInserting Shoulder Screws
  4. Connect the power supply to the power port. Connect any additional cables into the appropriate ports shown in Figure 3 CC6000 Power and Cable Ports and Figure 6 CC600 Power and Cable Ports.
  5. Mount the device by placing the shoulder screws through the four keyholes on the mounting plate, and slide the device down to secure it in place.
    Attaching the Device to the Bracket
    Attaching the Device to the Bracket
    Attaching the CC6000 Portrait to the Bracket
    1
    To wall
  6. Insert the locking screw through the hole in the tab at the top of the mounting plate. Hand-tighten the screw to secure the device.