Installing the Power Pre-Regulator
Installing the Power Pre-Regulator

Installing the Power Pre-Regulator

The pre-regulator is a DC/DC power supply and is available as an accessory. It should be used when the power source (usually the forklift truck battery) exceeds the input range of the VC8300 power supply (for example, trucks equipped with a 72 VDC battery).
It is recommended that all connections be secured with electrical tape or heat shrink to prevent contaminants from degrading the connection.
The Zebra power extension cable positive lead is red and the negative lead is black.
  1. Attach the pre-regulator cable male connector to the Zebra power extension cable which is installed on the vehicle.
  2. Connect the pre-regulator cable female connector either directly to the device's power cable, or to the power extension cable.
    Connections To Vehicle DC Supply - Without Power Pre-regulator For vehicles with DC power 48V or less
    VC8300 Connections To Vehicle DC Supply
    1
    DB9 Cable
    2
    Lines to screen-blanking sensor (optional)
    3
    Lines to ignition switch (optional)
    4
    Extension power cable
    5
    Fuse
    6
    Positive Connection
    7
    Vehicle DC Power Source (12 VDC to 48 VDC nominal)
    8
    Negative Connection
    9
    Power Extension with Ignition Sense (p/n CA1220)
    10
    Power Extension without Ignition Sense (p/n CA1210)
    11
    Power Cable
    Connections To Vehicle DC Supply - With Power Pre-regulator For vehicles with DC power greater than 48V
    1
    DB9 Cable
    2
    Lines to screen-blanking sensor (optional)
    3
    Lines to ignition switch (optional)
    4
    Power pre-regulator
    5
    Power Extension without Ignition Sense (p/n CA1210)
    6
    Extension Wire
    7
    Fuse
    8
    Positive Connection
    9
    Vehicle DC Power Source (12 VDC to 48 VDC nominal)
    10
    Negative Connection
    11
    Power Extension for Pre-Regulator with Ignition Sense (p/n CA1230)
    12
    Power Cable