Manually Calibrating the Printer
Manually Calibrating the Printer

Manually Calibrating the Printer

It is recommended that you calibrate the printer manually when using pre-printed media or if the printer will not correctly auto-calibrate when you run a SmartCal procedure.
Make sure media is loaded. A good common label size is 4 by 6 inches.
  1. Turn printer power ON.
  2. Send this command to the printer:
    ! U1 do "ezpl.manual_calibration" ""
The printer will set the media sensor for the label backing in use. When this adjustment is complete, the printer will auto-feed the media roll until a label is positioned at the printhead. It will then print a profile of the media sensor settings (similar to the one shown here). When done, the printer will save the new settings in memory. It is now ready for normal operation.
This image shows the start of several labels (at the right).
This image shows the end of several labels (at the left).