capture.channel1.delimiter
capture.channel1.delimiter

capture.channel1.delimiter

This command stores the delimiter used to partition data received on the port specified by
capture.channel1.port
and stored in
capture.channel1.data.raw
and
capture.channel1.data.mime
.
This will be reported in the data capture section of the
HZA
response.

Setvar

To set the delimiter used to partition data received on the
capture.channel1.port
:
! U1 setvar "capture.channel1.delimiter" "delimiter"
Values
Any character set up to a maximum of 64 characters in length.
Binary data can be used in the delimiter. To do this enter a '\' and then the 3 digit octal value of the character.
"\\"
=
'\'
in some tools, so to get
\002
you may need to enter
“\\002”
. Escaped octal characters count as a single character and not 4 (e.g. a delimiter of
“\001\000\002”
is 3 characters, not 12)
Default
"\012"

Getvar

To retrieve the delimiter:
! U1 getvar "capture.channel1.delimiter"
Example
Binary data can be used in the delimiter. To do this enter a
'\'
and then the 3 digit octal value of the character. Note:
"\\"
=
'\'
in some tools, so to get
\002
you may need to enter
"\\002"
.
"\000" = NULL (single character) "end\015\012\000" = 'e'+'n'+'d'+'\r'+'\n'+ NULL (total of 6 characters