device.applicator.voltage
device.applicator.voltage

device.applicator.voltage

Sets the output voltage of the applicator board. The value will not take effect until a reboot.

Setvar

To set the output voltage of the applicator board:
! U1 setvar "device.applicator.voltage" "value"
Values
  • "0"
    indicates off
  • "5"
    indicates 5V
  • "24"
    indicates 24V
Default
"disabled"

Getvar

To retrieve the current setting value:
! U1 getvar "device.applicator.voltage"
Result
"5"
Example
In the setvar example below, the output voltage of the applicator board is set to
"5"
.
! U1 setvar "device.applicator.voltage" "5"