rfid.tag.test
rfid.tag.test

rfid.tag.test

This command performs an RFID test. In the RFID test, the printer attempts to read and write to a transponder that you place over the RFID antenna. Results are displayed on the printer’s control panel display.
For more information about the RFID antenna location, refer to the RFID Programming Guide for your printer. A copy is available online at www.zebra.com/manuals.
In the slow version of the RFID test, the printer first displays the hardware version, the reader firmware version, and the program position.
This command is valid only on RP4T printers.

Setvar

To set the programming position:
! U1 setvar "rfid.tag.test" "value"
Values
"quick"
"slow"
Example
This
setvar
example performs a quick RFID test, which shows a pass or fail message.
! U1 setvar "rfid.tag.test" "quick"
This
setvar
example performs a slow RFID test, which shows the success or failure of each read or write tag operation.
! U1 setvar "rfid.tag.test" "slow"