^NC
^NC

^NC

The
^NC
command selects the wired or wireless print server as the primary network device.

Select the Primary Network Device

Supported Devices:
  • Xi4, RXi4
  • ZM400/ZM600, RZ400/RZ600
The Xi4, RXi4, ZM400/ZM600, and RZ400/RZ600 printers support the simultaneous installation of an internal, external, and a wireless print server. Even though all three print servers may be installed, only one is connected to the network and is the active print server. This table outlines priorities and identifies which device becomes the active print server when multiple print servers are installed.
Effect of Primary Network Setting on Active Print Server
If the Primary Network is set to:
Installed and Connected to a Live Ethernet Network
Then, the Active Print Server will be:
Internal
External
Wireless
Wired
X
X
X
Internal
X
X
External
X
Wireless
Wireless
X
X
X
Wireless
X
X
Internal
X
External
A wireless option board must have an active radio that can properly associate to an access point.
Format:
^NCa
Parameters
Details
a =
primary network device
Values:
1 =
wired primary
2 =
wireless primary
Default:
1
must be an accepted value or it is ignored