internal_wired.auto_switchover
internal_wired.auto_switchover

internal_wired.auto_switchover

This command instructs the printer to switch from wireless to the internal wired print server when an Ethernet cable is plugged into the printer and the printer detects an active data link.

Setvar

To configure switches between the wireless and wired interfaces:
! U1 setvar "internal_wired.auto_switchover" "value"
Values
  • "on"
    indicates switchover enabled
  • "off"
    indicates switchover disabled
Default
"off"

Getvar

To retrieve the current automatic switchover value:
! U1 getvar "internal_wired.auto_switchover"
Example
This
setvar
example shows the value set to
"off"
.
! U1 setvar "internal_wired.auto_switchover" "off"
When the
setvar
value is set to
"off"
, the
getvar
result is
"off"
.
For this command to work, be sure:
  • you are using a ZM400/ZM600 or RZ400/RZ600 printer with both the internal 10/100 wired print server and wireless option board installed
  • the value for this command is set to
    "on"
    (switchover enabled)
  • the printer is currently communicating to the network through a wireless connection
  • a Ethernet cable is plugged into the ZM400/ZM600 or RZ400/RZ600 printer and the printer recognizes a data link connection
When the above conditions exist and an active Ethernet cable is plugged into an internal wired print server, the printer will detect the wired data link and automatically switch to the wired interface. The printer will automatically switch back to the wireless interface when the Ethernet cable is disconnected.