weblink.zebra_connector.authentication.add
weblink.zebra_connector.authentication.add

weblink.zebra_connector.authentication.add

This command allows the user to add a single server/username/password triplet into the list of authentication entries.
When the printer attempts to connect to the Zebra Printer Connector, the local server may require HTTP authentication (e.g. digest, basic, DNS, etc.). There may be multiple authentication requests along the route to the destination (e.g. a local server first requires HTTP authentication as well as on the remote server).
For each HTTP authentication request received while attempting to connect, the printer will enumerate the authentication entries and attempt to satisfy the request with the username/password pair provided for the respective server. The server name in the entry is what determines which username/password pair should be used for which authentication request. Both DNS names and IP addresses are acceptable. The server, username, and password are separated by a single space (not a tab or other white space character). The server name is the only required field. If no username is supplied, but a password is, there must be two spaces between the server and the password fields. If there is a username but no password, or simply just the servername, no space is required at the end of the entry.
If the command is changed while the Visibility Agent is enabled, it will not take effect until the connection is disabled, and then re-enabled.
This setting can only be changed when weblink.zebra_connector.enable is set to
"off"
.
^JUF, ^JUS, ^JUN, ^JUA
, and
device.restore_defaults
do not have any affect on this setting.

Setvar

To allow the user to add a single server/username/password triplet into the list of authentication entries:
! U1 setvar "weblink.zebra_connector.authentication.add" "server username password"
Values
  • "server"
    is the IP address or a DNS name
  • "username"
    is the user name on this server
  • "password"
    is the password for this username on this server
Default
""
Result
! U1 setvar "weblink.zebra_connector.authentication.add"
"10.3.5.70 jsmith LedZepR0cks!"