weblink.zebra_connector.proxy
weblink.zebra_connector.proxy

weblink.zebra_connector.proxy

This command assigns the URL for the proxy used to connect to the Zebra connector.
The proxy server protocol, port, domain, username, and password are all encoded into the URL via the format outlined in RFC2396 (http://www.ietf.org/rfc/rfc2396.txt).
The username and password must avoid the invalid characters listed in RFC2396 (e.g. ':', '@', '/', etc). If an invalid character must be used it needs to be escaped using '%' as described in RFC2396.
^JUF, ^JUS, ^JUN, ^JUA
, and
device.restore_defaults
do not have any affect on this setting.

Setvar

To assign the URL for the proxy used to connect to the Zebra connector:
! U1 setvar "weblink.zebra_connector.proxy" "url"
Values
Any valid URL up to 2048 characters
Expected URL format: [http|https]://[user:pass@]domain[:port]/[path]
The URL will need to be built according to the server/proxy environment the printer is running where:
  • "user"
    username
  • "password"
    password
  • "host"
    either the hostname or IP address
  • "port"
    port number
  • "other"
    anything else needed in the path
Default
""
  • The user:pass, port, and path are all optional.
  • The default scheme must be either
    HTTPS
    or
    HTTP
    . The default is
    HTTP
    .
  • The default port is 1080.
The default is to omit the username and password.
Example
! U1 setvar "weblink.zebra_connector.proxy" "https://user:pass@my.internal.proxy:7840/init"

Getvar

To return the current setting value:
! U1 getvar "weblink.zebra_connector.proxy"
Result
"https://user:pass@my.internal.proxy:7840/init"