wlan.leap_mode
wlan.leap_mode

wlan.leap_mode

This printer setting refers to Cisco LEAP (Lightweight Extensible Authentication Protocol). LEAP provides secure mutual authentication for a wireless client through a Cisco Aironet Access Point, based on user information stored on a backend RADIUS (Remote Authentication in Dial-Up User Service) /AAA (Authentication, Authorization, and Accounting) server.
  • This command is only supported on printers using firmware Vxx.18.xx or earlier.
  • This command is not supported on units with a Frequency Hopping Spread Spectrum (FHSS) radio.

Setvar

To turn the LEAP mode
"on"
or
"off":
! U1 setvar "wlan.leap_mode" "values"
Values
"off"
disables LEAP mode
"on"
enables LEAP mode
Default
"off"

Getvar

To respond with the LEAP mode:
! U1 getvar "wlan.leap_mode"
Example
This
setvar
example shows the value set to
"on"
.
! U1 setvar "wlan.leap_mode" "on"
When the
setvar
value is set to
"on"
, the
getvar
result is
"on"
.