Pairing Using Bluetooth Human Interface Device

Pair the Ring Scanner to the device using Human Interface Device (HID).

Ensure that Bluetooth is enabled on both devices.

Ensure that the Bluetooth device to discover is in discoverable mode.

Ensure that the two devices are within 10 m (32.8 ft) of one another.

Place the Ring Scanner in HID mode. If the Ring Scanner is already in HID mode, skip to step 5.

Remove the battery from the Ring Scanner.

Press and hold

Restore

Install the battery onto the Ring Scanner.

Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.

Scan the barcode below to place the Ring Scanner in HID mode.

RS507 Bluetooth HID Barcode

Remove the battery from the Ring Scanner.

Re-install the battery into the Ring Scanner.

Swipe down from the Status bar to open the Quick Access panel and then touch

Touch

Bluetooth

Touch

Pair new device

. The device begins searching for discoverable Bluetooth devices in the area and displays them under

Available devices

Scroll through the list and select Ring Scanner.

The device connects to the Ring Scanner and

Connected

appears below the device name. The Bluetooth device is added to the

Paired devices

list and a trusted (“paired”) connection is established.

A notification appears on the Notification panel and the

icon appears in the Status bar.