Status Indications
Status Indications
View content for :
Product:

Status Indications

The
RS2100
notification LED
on the back of the device indicates
Bluetooth, battery,
and decode status. The beeper emits beep sequences and patterns to indicate status.
The following table defines the
notification
LED and beep sequence status indications.
Category
LED Indication
Beep Indication
Description
Power Indication
Green
Low/medium/high
Device is powered on.
Scanning Indications
Green single flash
High
Successful barcode decode.
Red
4x low
Transmission error.
Red
5x low
Conversion or format error.
Red
Low/high/low/high
Out of batch memory storage. Unable to store a new barcode.
Radio Indications
Red/Green blinking
6x short/high
Device in paging state.
Blue double blink
High/low
Bluetooth communication is disconnected.
Blue slow blinking
None
Attempting to reconnect over Bluetooth.
None
Low/high
Bluetooth connection established.
None
Long low/long high
Bluetooth connection attempt failed.
Blue during beep sequence
Long low/long high/long low/long high
Bluetooth connection attempt rejected.
Blue slow blinking
5x high
Attempting to reconnect over Bluetooth (disabled by default).
Blue blinking
3x high
Bluetooth disconnect indication (disabled by default).
Battery Indications1 (hold trigger for three seconds to activate).
Red
4x high
Battery charge is low.
Green
N/A
High
Amber
N/A
Medium
Red
N/A
Low
Charging Indications
Amber
N/A
Scanner is charging. Battery level is 0% - 98%.
Green
N/A
Scanner is charged. Battery level is 98% - 100%.
Red flash, then no illumination
N/A
Scanner temperature is too high. Charging is paused until scanner temperature decreases2.
Parameter Programming
Red
Long low/long high
Input error, incorrect barcode or
Cancel
scanned, wrong entry, incorrect barcode programming sequence; remain in program mode.
Green
High/low/high/low
Successful program exit with change in the parameter setting.
Maintenance Indications
Green slow blinking
N/A
Scanner connected to 123Scan.
Red fast blinking
N/A
A file is transferring to the scanner (new configuration parameters or firmware) via 123Scan.
Red slow blinking
N/A
Firmware installation.
Green
N/A
Programming completed successfully (parameter changes or firmware updated) via 123Scan.