Printing on Fanfold Media

Printing on Fanfold Media

Printing on fanfold media requires you to adjust the media guides stop position.
  1. Open the top cover.
  2. Adjust the media guide stop position with the gold thumb wheel. Use a piece of the fanfold media to set the stop position. Rotate the wheel away from you to make the guides wider. Rotate the wheel toward you to make the media guides narrower.
  3. Insert the media through the slot at the rear of the printer and place the media between the media guide and roll holders.
  4. Close the top cover.
  5. If, after the printer prints or feeds several labels, you notice that the media does not track down the center (moves from side to side) or if the sides of the media (liner, tag, paper, etc.) are frayed or damaged when exiting the printer, you may have to adjust the media guides. If this does not correct the problem, you can route the media over the two roll holding pins on the media guide. For thin media, you can place an empty roll core of the same width as the stack of fanfold media between the roll holders to provide additional support.