Attaching Power

Attaching Power

Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!
Set up your printer so that you can handle the power cord easily if needed. Some processes for setup or troubleshooting issues may ask you to remove power. Separate the power cord from the power supply receptacle or AC electrical outlet to make certain the printer cannot carry electrical current.
Ensure the appropriate power cord with a three-prong plug and an IEC 60320-C13 connector are used at all times. These power cords must bear the relevant certification mark of the country in which the product is being used.
  1. Plug the power supply into the printer’s DC power receptacle.
  2. Insert the AC power cord into the power supply.
  3. Plug the other end of the AC power cord into an appropriate AC electrical outlet.
    The plug on the AC outlet end of the power cord may vary by region.
  4. Verify that the active power light shows green, indicating that power is on at the AC outlet.