This option kit modifies the printer to use media rolls with larger inner roll core diameters.
The media roll adapters option kit includes the screws to attach them. The kits are for the following inner diameter media cores:
38.1 mm (1.5 in.)
50.8 mm (2.0 in.)
76.2 (3.0 in.)
Adapter Usage
The adapters are intended to be permanently installed in the printer.
Adapters may be changed to support other media roll sizes.
The adapters may loosen if they are changed too many times.
Remove any debris from the media roll bay before placing a new media roll.
Installing Media Roll Adapters
Each roll holder gets one adapter.
Place the adapter onto the roll holder.
Attach the adapter to the roll holder using a screw.
Tighten the screw until there is no gap between the adapter and the roll holder. Do not tighten beyond this point. Over-tightening will strip the thread.
Repeat for the other adapter and roll holder.
Example of a label roll (1) placed on the adapters.
Example of Label Roll with 38.1 mm (1.5 inches) Inner Core mounted on Media Core Adapters.
