ZD888TA/ZD230TA Thermal Transfer Desktop Printer User Guide

Attaching Power

Use this procedure to connect power to the printer.

NEVER operate the printer and power supply in an area where they can get wet. Serious personal injury could result!

Use ONLY the appropriate power cord with a three-prong plug and an IEC 60320-C13 connector at all times. The power cords MUST bear the relevant certification mark of the country in which the product is being used.

Set up your printer so that you can handle the power cord easily if needed. Some setup or troubleshooting tasks may instruct you to switch printer power OFF. Separate the power cord from the power supply receptacle or AC electrical outlet to make certain the printer cannot carry electrical current.

Plug the power supply into the printer’s DC power receptacle.

Insert the AC power cord into the power supply.

Plug the other end of the AC power cord into an appropriate AC electrical outlet. (The AC-outlet end of the power cord’s plug type can vary by region.)

The active power light will turn on green if power is on at the AC outlet.