Issue: Label Job Sent, No Data Transfer
Issue: Label Job Sent, No Data Transfer

Issue: Label Job Sent, No Data Transfer

Condition

A label format was sent to the printer but was not recognized. The
DATA
indicator does not flash.

Cause

The communication parameters are incorrect for typically serial interface communications.

Remedy

Internal Printer Support
  • Check the printer driver or software communications settings (if applicable).
  • Serial Port Only - Check the printer’s handshake protocol and serial port settings. The setting used must match the one being used by the host computer.
  • The serial cable you are trying to use may not be a standard DTE or DCE type cable, is damaged, or is too long per the RS-232 Serial ports specifications
  • The interface cable may be too long, does not meet interface specifications, not properly shielded or routed by electronic noise sources (fluorescent lights, transformers, motors, etc.).
  • See Serial Interface (setup),  Interface Cable Requirements, and
    Serial Port Interface
    (connector wiring).