The Connectivity Gateway operates in Single Shot, Continuous, or Level mode.
Navigate to the
Configuration
screen from the
Home
screen using the left navigation menu.
Use the bottom right
Run Mode
section on the
Configuration
screen to change between
Single Shot
,
Continuous
and
Level
modes.
Click
Config
to edit
Run Mode
settings.
Configure the required trigger settings:
Level Mode - determines how a level starts and stops. The default setting is
Active
. When set to
Active
, the level starts/stops on active high or low. Set this value to
Pulse
to start or stop a level when the trigger tag goes high or low twice. This can increase workflow efficiency by terminating data capture processes once a successful decode is achieved, preventing unnecessary resource usage.
Grace Period - the amount of time to wait after a level stop signal is received to accept incoming barcodes before rejecting them.
Stop Mode - determines how the level session stops. The default setting is
Normal
. When set to
Normal
, the application waits for the stop trigger signal from the host or GPIO and forwards the data to the followers. When set to
On Decode
, the application immediately sends the stop trigger to the followers upon the first decode.
Output Mode - determines how barcodes are output over all configurable host interfaces while running in level mode. The default setting is
As Received
. When set to
As Received
, barcodes are sent as received. When set to
Level End
, barcodes are combined into a single payload separated by the output delimiter.
Output Delimiter - determine the delimiting characters separating the barcode output after a level session when running in
Level End
output mode.
Click
Update
for the changes to take effect.
Observe the warning screen indicating that scan data is erased after the changes are implemented. Acknowledge the warning to proceed with your changes.
