To read a bar code, a scan-enabled application is required. The device contains the DataWedge application that allows the user to enable the imager, decode the bar code data and display the bar code content.
Ensure that an application is open on the device, and a text field is in focus (text cursor in text field).
Point the exit window at a bar code on top of the device.
Press and hold the scan button.
The red laser aiming pattern turns on to assist in aiming.
When the device is in Picklist mode, the imager does not decode the barcode until the crosshair or aiming dot touches the barcode.
Ensure the barcode is within the area formed by the cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
Aiming Pattern
Pick List Mode with Multiple Barcodes in Aiming Pattern
The Data Capture LED lights green, and a beep sounds, by default, to indicate the barcode was decoded successfully.
Release the scan button.
Imager decoding usually occurs instantaneously. The device repeats the steps required to take a digital picture (image) of a poor or difficult barcode as long as the scan button remains pressed.
The barcode content data is displayed in the text field.
