1. WT6300 Product Reference Guide for Android™
  2. Accessories
  3. RS4000 Scanner
  4. Connecting the RS4000 Scanner
  • WT6300 Wearable Computer Product Reference Guide for Android™
Connecting the RS4000 Scanner

Connecting the RS4000 Scanner

This section describes connecting an RS4000 scanner to the device.
  1. Connect the scanner interface cable to the device interface connector. If the device is mounted on the arm, connect the cable to the interface connector closest to the wrist.
    Scanner cable connects to WT6300 port.
    1
    Interface connector
    2
    Cable connector
  2. If using the extended cable configuration, route the scanner cable up to the shoulder and down to the hand that the scanner mounts on. Attach two cable clips to clothing and secure cable to cable clip.
    Long cable connecting from hip to finger-mounted scanner.
  3. Rotate the trigger assembly to the correct position for the hand that the scanner mounts to.
  4. Slide the scanner onto the index finger with the scan trigger next to the thumb.
    Scanner on finger, thumb next to trigger.
  5. Tighten the finger strap.
    Pulling strap to tighten and secure.
  6. Soft boot the wearable terminal. See Performing a Soft Reset for information on performing a soft boot.