t-zt2x0-final-steps-for-tear-off-mode
Final Steps for Tear-Off Mode

Final Steps for Tear-Off Mode

  1. Slide in the outer media guide until it just touches the edge of the media.
  2. Rotate the printhead-open lever downward until it locks the printhead in place.
  3. Set the printer to Tear-Off mode (for more information, see Print Mode).
  4. Close the media door.
  5. Press
    PAUSE
    to exit pause mode and enable printing.
    The printer may perform a label calibration or feed a label, depending on your settings.
  6. For optimal results, calibrate the printer. See Calibrating the Ribbon and Media Sensors.
  7. Verify that your printer is able to print a configuration label by holding both the
    FEED
    and
    CANCEL
    keys for 2 seconds.
    Media loading in Tear-Off mode is complete.