Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
123RFID Mobile Application for iOS User Guide
123RFID Mobile Application for iOS
Batch Mode
Setting Batch Mode to Auto
123RFID Mobile Application for iOS User Guide
123RFID Mobile Application for iOS User Guide
About this Guide
Notational Conventions
Icon Conventions
Service Information
123RFID Mobile Application for iOS
Overview
Installing the 123RFID Mobile Application for iOS
Using the Application
Navigating 123RFID Mobile
Home Screen
Tab Bar
Readers List
Pairing a Device
Unpairing a Device
Pairing the RFD8500
Pairing the RFD40+
Setting Up the NFC-Based Tap to Pair
Manually Pairing a Device
RFID Operations
Rapid Read
Inventory
Memory Bank
Power Management
Search a Tag
Content Area (Select a Tag)
Unique Tag Reporting
NXP BrandID Check
Locate Tag
Locating a Single Tag
Locating Multiple Tags
Setting Pre Filters
Tag Access Operation
Read/Write
Lock
Kill
Settings
Readers List
Profiles
Advanced Reader Options
Antenna
Singulation Control
Start/Stop Trigger
Tag Reporting
Save Configuration
Power Management
Regulatory
Battery Status
Beeper Settings
Scanner Settings
Beeper
Symbologies
Aim On/Off
Device Information
Trigger Mapping
Firmware Update
Updating Firmware
Locating a Reader
Batch Mode
Setting Batch Mode to Auto
Enabling Batch Mode
Disabling Batch Mode
Auto Reconnect
Enabling Auto Reconnect
Disabling Auto Reconnect
SGTIN-96 Encoding
Scanner Batch Mode
WLAN
Creating a WLAN Profile
WLAN Status and Settings
Endpoint Configuration
About
Battery Support
Factory Reset
Setting Batch Mode to Auto
Setting Batch Mode to Auto
This setting sets the batch mode to auto.
Set the batch mode to auto.
Start the Inventory and exit the application.
Connect to the reader (after Bluetooth is out of range).
Go to the Inventory screen and tap
Stop
.
The application displays tags read when Bluetooth is out of range.
Batch Mode
