Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
ET40/45 Presentation Stand User Guide
Getting Started
Installing the Presentation Back
ET40/ET45 Presentation Stand
ET40/ET45 Presentation Stand
About this Guide
Accessories List
Notational Conventions
Icon Conventions
Service Information
Getting Started
Presentation Stand
Cable Routing
Mounting the Presentation Stand
Installing the Presentation Back
Using the Stand
Setting the Locking Mode
Docking the Tablet
Removing the Tablet
Adjusting the Stand
Presentation Stand API
Specifications
Installing the Presentation Back
Installing the Presentation Back
Power off the device before installing or removing the Presentation back.
Do not use any tools for battery cover removal. Puncturing the battery or seal may cause a hazardous condition and a potential risk of injury.
Remove battery cover and store in safe place.
Insert the tabbed end of the Presentation back into the slots in the battery well (1).
Rotate the cover down (2).
Carefully press down around the edges of the cover. Make sure that the cover is seated properly.
Using a T5 Torx screwdriver, secure the Presentation back to device using four M2 screws. Torque to 0.43N-m.
Getting Started