1. Guide de l'utilisateur des imprimantes industrielles avec écran tactile couleur ZT610/ZT620
  2. Configuration de l'imprimante
  3. Chargement du support
  4. Finish Loading the Media – Cutter Mode or Delayed Cut Mode
  • Guide de l'utilisateur des imprimantes industrielles avec écran tactile couleur ZT610/ZT620
Finish Loading the Media – Cutter Mode or Delayed Cut Mode
Finish Loading the Media – Cutter Mode or Delayed Cut Mode

Finish Loading the Media – Cutter Mode or Delayed Cut Mode

Before proceeding, if you have not already done so, complete the steps in Chargement du support.
  1. Open the printhead assembly by rotating the printhead-open lever upward.
  2. Rotate the media guide adjustment knob as shown until the media guide slides all the way out.
    La tête d'impression peut être chaude et causer de graves brûlures. Laissez la tête d'impression refroidir.
  3. From the media spindle (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
    La lame de coupe est bien aiguisée. Ne touchez pas et ne frottez pas la lame avec vos doigts.
  4. Feed the media through the cutter.
  5. Rotate the media guide adjustment knob as shown until the media guide just touches the edge of the media.
  6. Does the media that you are using require ribbon for printing? If you are not sure, see Ruban.
    If using...
    Then...
    Direct Thermal media (no ribbon needed)
    Continue to the next step in this procedure.
    Thermal Transfer media (ribbon needed)
    If you have not already done so, load ribbon in the printer. See Chargement du ruban. Then continue to the next step in this procedure.
  7. Rotate the printhead-open lever downward until it locks the printhead in place.
  8. Close the media door.
  9. Set the printer to the appropriate collection method. See
    Print
    Label Position
    Collection Method
     in Menu Imprimer.
  10. Press
    PAUSE
     to exit pause mode and enable printing.
    The printer may perform a label calibration or feed a label, depending on your settings.
  11. For best results, calibrate the printer. See Étalonnage des capteurs de ruban et de support.
  12. If desired, print a configuration or other label to verify that your printer is able to print. See
    System
    Settings
    Print: System Settings
     in Menu Système.