How to Load Roll Media –
ZD411T

This procedure works for Tear-Off (standard bezel), Label Dispense, and Media Cutting printer options.

Slide the release latches to the front to unlock the cover.

Spread the roll holders open and place the roll into the printer.

Verify the roll turns freely. The roll must not sit in the bottom of the media compartment.

Pull the end of the roll past the front edge of the printer.

Push the media under both of the media guides.

Flip the media up to access the sensor and the backside of the media.

Align the movable media sensor for your media type.

1 – Default Sensor Position (transmissive web/gap sensing)

2 – Standard Labels

3 – Standard Receipt (continuous roll shown in the printer)

1 – Off-Center Positions (Reflective)	3a – Blackline Label	4a – Black Mark Label (shown in the printer)
2 – Notched or Hole (label or tear-off)	3b – Blackline Tear-Off (continuous)4b – Black Mark Tear-Off (continuous)	4b – Black Mark Tear-Off (continuous)