1. ZD411T Thermal Transfer Printer
  2. Print Operations
  3. Printing on Fan-Fold Media
  • ZD411T Thermal Transfer Link-OS™ Desktop Printer
Printing on Fan-Fold Media
View content for :
Product:

Printing on Fan-Fold Media

The printer can use fan-fold media via a media access slot in the rear of the printer.
  1. Remove any roll media from the printer.
  2. Open the top cover.
  3. Adjust the media guide stop position with the gray slide-lock. It is located on the outside of the left media roll holder. Use a piece of your fan-fold media to set the stop position's width  Push the gray slide-lock towards the rear of the print to lock its position.
  4. Insert the media through the slot at the rear of the printer and place the media between the media guide and roll holders.
  5. Close the top cover.
After printing or using the
FEED
 button to advance several labels: If the media does not track down the center (moves the stack from side to side) or the sides of the media (liner, tag, paper, etc.) are frayed or damaged when exiting the printer, then the media guide stop position may need further adjustment.
If this does not correct the problem, then the media can be routed over the two roll-holding pins on the media guide depending upon your media.
An empty roll core of the same width as the stack of the fan-fold media can be placed between the roll holders to provide additional support for thin media.