You may need to manually calibrate the printer if you see issues with the print output.
Touch
Print
Sensors
Manual Calibration
.
Touch
Start Calibration
.
Follow the steps in the calibration procedure as prompted.
When performing manual calibration with a linerless cutter, remove any media that extends out of the cutter. Leaving any media sticking out can block the label taken sensor (1), so calibration will fail.
Follow the calibration procedure exactly as presented.
Touch
Next
to advance to the next prompt.
You may press and hold
CANCEL
on the control panel at any step in the procedure to cancel the calibration process.
