Open the printhead assembly by rotating the printhead-open lever upward.
Slide the media guide all the way out.
HOT SURFACE:
The printhead may be hot and could cause severe burns. Allow the printhead to cool.
From the media hanger (1), feed the media under the dancer assembly (2), through the media sensor (3), and under the printhead assembly (4). Slide the media back until it touches the inside back wall of the media sensor.
Extend approximately 18 in. (500 mm) of media out of the printer.
Feed the media over the peel assembly.
Thread the media into the slot below the peel assembly.
Feed the media under the media alignment roller.
Loosen the thumbscrew on the rewind media guide.
Slide the rewind media guide all the way out, and then fold it down.
Slide an empty core onto the rewind spindle.
Wrap the media around the core as shown and turn the rewind spindle to tighten the media. Ensure that the edge of the media is flush against the backplate of the rewind spindle.
Fold up the rewind media guide, and then slide it in until it touches the media.
Tighten the thumbscrew on the rewind media guide.
Slide in the media guide until it just touches the edge of the media.
Does the media that you are using require ribbon for printing? If you are not sure, see Ribbon.
