ZT411/ZT421 Industrial Printer User Guide

Inserting the Media into the Printer

Raise the media door.

Remove and discard any tags or labels that are torn or dirty or that are held by adhesives or tape.

Pull out the media supply guide as far as it goes.

Insert roll or fanfold media into the printer. The media loading path is the same for both roll and fanfold media, so this is the only step that will be different.

Type of media	Instructions
Roll media	Place the roll of media on the media supply hanger. Push the roll as far back as it will go.
Fanfold media	Fanfold media can be stored behind or under the printer. Depending on where the media is stored, feed the media either from behind or through the bottom access slot, then drape it over the media supply hanger.

Rear Feed	Bottom Feed

Which collection method are you using? (See Determining the Media Handling Method.)

If using...	Then...
Tear Off	Continue with Using Tear-Off Mode.
Peel Off (with or without liner take-up)	Continue with Using Peel-Off Mode (with or without Liner Take-Up).
Rewind	Continue with Using Rewind Mode.
Cutter or Delayed Cut	Continue with Using Cutter Mode or Delayed Cut Mode.
Linerless Cut or Delayed Linerless Cut	Continue with Using Linerless Cut Mode.