Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
RS5 Series
RS5000x Quick Start Guide
Replacing the RS5000x Finger Strap
RS5000/RS5000x
RS5000/RS5000x
Service Information
Introduction
RS5000 Features
RS5000x Features
Changing Trigger Position
Connecting the Scanner to a Host Device
Connecting the Scanner to a Hip-Mounted Host Device
Mounting the Scanner
Using the Scanner
Scanning Tips
RS5000XFirmware Update
Viewing the Current Firmware Version
Updating Firmware
Replacing the Finger Strap Assembly
Replacing the RS5000x Finger Strap
Replacing the Trigger Assembly
Cleaning
Cleaning the Housing
Cleaning the Exit Window
Cleaning the Connector
Troubleshooting
Ergonomic Considerations
Replacing the RS5000x Finger Strap
Replacing the RS5000x Finger Strap
The finger strap can be changed for each user or replaced when it is worn out.
Open the strap buckle.
Remove the strap from the buckle.
Use a small flathead screwdriver to release the strap pin from the trigger assembly.
Guide one side of the new strap pin into a slot of the trigger swivel assembly.
Use the screwdriver to push the other side of the strap pin into its slot.
Pull the finger strap through the buckle.
