Feed one label | To advance the media by one blank form or format (one label, receipt, tag, ticket, etc.), wait for the printer to stop printing. Press the FEED button, and release it within two seconds. |
Reprint last label | To activate the Enable Reprint feature, send the printer an SGD command ( ezpl.reprint_mode OR the ZPL ^JJ command parameters D and E ), then use the FEED button as the ‘applicator signal’.This enables a reprint of a failed media print. If the printer runs out of media (paper, labels, etc.), it can reprint the last label (print form/format) from its print storage buffer as described above. Do NOT turn printer power off or reset the printer if you want to reprint. These actions clear the print buffer. |
Stop print activities and place the printer into a PAUSE state | Press the FEED button while printing.The printer will finish printing the label it is printing before it enters a PAUSE state. |
Return the printer to normal operation after the first three actions above | Press the FEED button while in the PAUSE state.If the printer is printing a multi-label (form/format) job or if another job is waiting in the print queue, the printer will resume printing. |
Initialize FEED button modes | You can access these advanced-operation FEED button modes by pressing the button for longer than two seconds. (See FEED Button Modes – Power ON and FEED Button Modes – Power OFF.) |
