ZD100TA Thermal Transfer Desktop Printer User Guide

FEED Button Modes – Power ON

This is the first of two advanced function sets accessible through the operation of the

FEED

button. (The other is

FEED

Button Mode - Power OFF.) By noting changes in the state and color of the STATUS indicator light — specifically the patterns of these changes — you can access the Power ON modes used to configure and set up the printer.

To access advanced operation Power ON modes, ensure the printer is ON and ready to print (STATUS indicator is lit up green). Then follow these instructions:

To...	Press and hold the FEED button for two seconds, then immediately release it and follow these instructions:	Result
Print a configuration report...	Wait for one flash of the STATUS indicator, then release the FEED button.	The printer prints a Configuration Report and exits Advanced Mode.
Calibrate the installed media⁠ (labels, paper, tags, etc.)⁠ using the Smart Cal routine and set the media-sensing parameters...	Continue holding the FEED button until the STATUS indicator flashes two times, then release the button.	The printer begins measuring media, sets the start of the media position, and exits Advanced mode.
Reset the printer to factory defaults...	Continue holding the FEED button until the STATUS indicator flashes three times, then release the button.	The printer resets to factory defaults (same result as after issuing the ZPL ^JUN command) and exits Advanced mode.
Return the printer to normal operating mode...	Release the FEED button two or more seconds after the third flash sequence.	The printer exits Advanced mode and returns to normal operating mode.