1. ZT510 Industrial Printer User Guide
  2. Printer Setup and Operation
  3. Select a Print Mode
  • ZT510 Industrial Printer User Guide
Select a Print Mode

Select a Print Mode

Use a print mode that matches the media being used and the printer options available. The media path is the same for roll and fanfold media.
To set the printer to use an available print mode, see PRINT MODE.
Print Modes and Printer Options
Print Mode
Description
This mode (default) can be used with any printer options and most media types.
The printer prints label formats as it receives them. The printer operator can tear off the printed labels any time after they print.
This mode can be used if the printer has a rewind option.
The printer peels the label from the liner during printing and then pauses until the label is removed. The backing is wound on the rewind spindle without using the rewind plate.
This mode can be used only if the printer has a rewind option.
The printer prints without pausing between labels. The media is wound onto a core after printing. The rewind plate is used to keep the labels from separating from the backing.
This mode can be used only if the printer has a cutter option.
The printer cuts between labels after each one is printed.
This mode can be used only if the printer has a cutter option.
The printer waits for a delayed cut ZPL command (~JK) before it cuts the last printed label.
* Reserved for future use.
This mode is for use with a machine that applies labels.
The printer prints when it receives a signal from the applicator. Refer to the Advanced User Information section of the Maintenance Manual for additional information about the applicator interface.