1. FXP20 POS RFID Reader Quick Start Guide
  2. Connecting the Cables and Power Supply
  • FXP20 RFID Reader
Connecting the Cables and Power Supply

Connecting the Cables and Power Supply

Connect the antennas and any other cables before connecting the power supply.
reader ports identified with callouts. Refer to the following table for callout information.
1
DC power
2
GPIO (cable not Included)
3
USB
4
Reset button
5
P4 external antenna (cable not included)
6
P3 external antenna  (cable not included)
7
P2 external antenna (cable not included)
  1. Attach the antenna cables and then torque to tighten.
    Antenna cable connector closeup.
    1. Attach an external antenna cable to P2, P3, and P4
    2. Torque to 3–5 in·lbf (0.3 to 0.6 N·m) for brass connectors, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors.
  2. Connect the USB cable and retaining screws to the reader and turn both retaining screws clockwise until tight.
    USB Cable inserting into the USB port.
  3. (Optional) Connect a GPIO cable.
    GPIO port closeup.
  4. Prepare the power supply as necessary.
    The following is an example. Use the power supply adapter applicable to your region.
    Adapter shown being inserted into the power supply. Adapter shown sitting in the power supply.
  5. Attach the power supply to the reader and turn the locking ring on the power cord clockwise until tight.
  6. Plug the DC power supply into the electrical outlet provided for this purpose.
    The LEDs on the device begin to illuminate.