To set the GS1 Digital Link Prioritization Timeout, scan the barcode below. Then, scan four barcodes from the
Numeric Barcodes corresponding to the desired prioritization time. Enter leading zeroes for times of less than 4 values. For example, to enter 250 msec, scan
0 2 5 0
. To correct an error or change the selection, scan
Cancel.
When the Digital Link Mode is set to Mode 2, the time specifies how long the scanner searches for a 2D GS1 Digital Link barcode. If the timer expires before finding the 2D GS1 barcode, the 1D barcode is sent.
When the Digital Link Mode is set to Mode 3, if the 1D barcode is decoded first, the timeout specifies how long the scanner continues to searches for a 2D barcode.
This parameter is set in 1 msec increments.
