RS-232 Host-Specific Parameter Settings
RS-232 Host-Specific Parameter Settings

RS-232 Host-Specific Parameter Settings

Some RS-232 hosts use their own parameter default settings.
You can select standard, ICL, Fujitsu, Wincor-Nixdorf Mode A or B, OPOS/JPOS, Olivetti, Omron, Common Use Terminal Equipment (CUTE-LP/LG barcode readers), NCR, or Datalogic and set the appropriate default.
RS-232 Host-Specific Settings
Parameter
ICL
Fujitsu
Wincor-Nixdorf Mode A
Wincor-Nixdorf Mode B/ OPOS/JPOS
Baud Rate
9600
9600
9600
9600
Parity
Even
None
Odd
Odd
Stop Bits
One
One
One
One
Data Bits
8-bit
8-bit
8-bit
8-bit
Hardware Handshaking
RTS/CTS Option 3
None
RTS/CTS Option 3
RTS/CTS Option 3
Software Handshaking
None
None
None
None
Serial Response Timeout
9.9 Seconds
2 Seconds
None
None
RTS Line State
High
Low
Low
Low = No data to send
Beep On <BEL>
Disable
Disable
Disable
Disable
Transmit Code ID
Yes
Yes
Yes
Yes
Data Transmission Format
Data/Suffix
Data/Suffix
Data/Suffix
Data/Suffix
Prefix
None
None
None
None
Suffix
CR (1013)
CR (1013)
CR (1013)
CR (1013)
In the Wincor-Nixdorf Mode A/B, when CTS is low, scanning is disabled and when CTS is high, scanning is enabled. If you scan Wincor-Nixdorf RS-232 Mode A/B without connecting the scanner to the proper host, it may appear unable to scan. In this case, scan a different RS-232 host type within 5 seconds of cycling power to the scanner.
RS-232 Host-Specific Settings
Parameter
Olivetti
Omron
CUTE
NCR
Datalogic
Baud Rate
9600
9600
9600
9600
9600
Parity
Even
None
Even
Odd
Odd
Stop Bits
One
One
One
One
One
Data Bits
7-bit
8-bit
7-bit
7-bit
7-bit
Hardware Handshaking
None
None
None
None
None
Software Handshaking
ACK/NAK
None
None
None
None
Serial Response Timeout
9.9 Seconds
9.9 Seconds
9.9 Seconds
9.9 Seconds
9.9 Seconds
RTS Line State
Low
High
High
High
High
Beep On <BEL>
Disable
Disable
Disable
Disable
Enable
Transmit Code ID
Yes
Yes
Yes
Yes
Yes
Data Transmission Format
Prefix/Data/ Suffix
Data/Suffix
Prefix/Data/ Suffix
Prefix/Suffix*
Data/Suffix
Prefix
STX (1003)
None
STX (1002)
STX *
None
Suffix
ETX (1002)
CR (1013)
CR (1013) ETX (1003)
ETX *
CR (1013)
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select CUTE, scan Enable Parameter Barcode Scanning, and then change the host selection.