Changing the Trigger Position for the Converged Scanner
Changing the Trigger Position for the Converged Scanner

Changing the Trigger Position for the Converged Scanner

The trigger assembly can be changed to accommodate left-hand or right-hand use.
Determine whether the WS50 Converged Scanner is used on the right or left hand so that the Scan Trigger is positioned next to the thumb.
The described procedures are applicable to both right-handed and left-handed users. The illustrations in this section show the steps to change the trigger position from right to left as an example.
  1. On the bottom of the device, lift the finger comfort pad from the front of the device, and then lift it from the rear.
    Lifting comfort pad
  2. Follow the instructions on the back of the device to unmount the trigger assembly.
    1. Unlock the trigger assembly by pushing the release latch to Unlock (4).
    2. Slide the trigger assembly following the Unlock (1) direction until the black triangle (2) is aligned with the engraved triangle (3).
      Trigger Handle Label
    3. Lift the trigger assembly.
      Lifting Trigger Assembly
  3. Rotate the trigger assembly so that the scan trigger is positioned next to the thumb.
  4. When replacing the trigger assembly onto the back of the core in the shell, ensure the black triangle (2) is aligned with the engraved triangle (3).
    Installing Trigger Assembly
  5. Slide the trigger assembly following the Lock (4) direction.
  6. Lock the trigger assembly by pushing the latch to the Lock (1) position, if necessary.
  7. Reattach the finger comfort pad onto the bottom of the device.