Mount the WS50 Back of Hand Mount (BOH) mount to the hand wrap, and then install the core in shell onto the BOH mount.
Determine whether the device is used on the right or left hand.
The described procedures are applicable to both right-handed and left-handed users. The steps in this section is using a right-hand wrap as an example.
The BOH mount has three slots for the user to position the trigger cable. Insert the trigger cable into one of the slots according to the size of the user's hand:
1
For large-hand users
2
For medium-hand users
3
For small-hand users
To mount a WS50 BOH mount to the hand wrap:
Insert the trigger cable and button (1) through the trigger slot of the hand wrap (2).
Insert the strap (2) through one of the strap slots (3) on the BOH mount (1).
Insert the strap through the other slot of the mount, and then fasten it with the hook and loop fastener.
Position the hand wrap on the hand by sliding your hand through the hand wrap, with your thumb through the smaller opening and your remaining four fingers through the larger opening.
Slide the strap (1) through the buckle and secure the end of the strap in place with the hook and loop fastener.
Adjust the strap to a comfortable position to fit securely by tightening or loosening the strap.
Position the trigger button so that the button is easy-access to your thumb, and then secure it on the hand wrap using the hook and loop fastener.
Slide the core (1) in shell onto the BOH mount. Press the BOH mount button (2) when mounting.
Release the button (2) when the device snaps into place on the BOH mount.
Reposition the mount on the hand wrap to align the mount with the middle finger knuckle.
Tighten or loosen the hand wrap strap, if necessary.
To unmount the core in shell from the BOH mount, press the BOH mount button and slide the core in shell away from the BOH mount button.
