Installing the Rewind/Liner Take-Up Plate – Peel Mode and Applicator Mode

Installing the Rewind/Liner Take-Up Plate – Peel Mode and Applicator Mode

These steps apply only to take-up plate installation for Peel mode and Applicator mode. To install the plate for Rewind mode, see Installing the Rewind/Liner Take-Up Plate – Rewind Mode.
  1. Loosen the knurled nut on the outside stud on the printer’s base.
  2. Align the large hole of the keyhole in the rewind/peel plate over the knurled nut, then slide the plate down until it hits the studs.
  3. Tighten the knurled nut.