Printing on Fanfold Media
Printing on Fanfold Media
View content for :

Printing on Fanfold Media

Printing on fanfold media requires you to adjust the media guide’s stop position.
  1. Open the top cover.
  2. Adjust the media guide stop position with the green thumb wheel for the width of the media loaded. Use a piece of the fanfold media to set the stop position. To open the guides wider, rotate the wheel toward you. To narrow the gap between the guides, rotate the wheel away from you.
  3. Insert the media through the slot at the rear of the printer.
  4. Run the media between the media guide and roll holders.
  5. Close the top cover.
After printing or feeding several labels: If the media does not track down the center (moves from side to side) or the sides of the media (liner, tag, paper, etc.) are frayed or damaged when exiting the printer, the media guides may need further adjustment.
If this does not correct the problem, the media can be routed over the two roll-holding pins on the media guide. An empty roll core of the same width as the stack of the fanfold media can be placed between the roll holders to provide additional support for thin media.