Cleaning and Lubricating the Cutter Module
Cleaning and Lubricating the Cutter Module
View content for :
Product:

Cleaning and Lubricating the Cutter Module

If the cutter is not cutting the labels cleanly or if it jams with labels, clean the cutter.
For personnel safety, always power off and unplug the printer before performing this procedure.
  1. Open the media cover.
    Open the media cover with the tear option
  2. Turn off (O) the printer and disconnect the AC power cord.
  3. Remove media that is loaded through the cutter module.
  4. Loosen and remove the thumbscrew and lock washer on the cutter shield.
    The cutter blade is sharp. Do not touch or rub the blade with your fingers.
  5. Remove the cutter shield.
  6. If necessary, rotate the cutter motor thumbscrew to fully expose the V-shaped cutter blade (1).
  7. Using the swab from the Preventive Maintenance Kit (part number 47362), wipe along the upper cutting surface and the cutter blade. In place of the Preventive Maintenance Kit, you may use a clean swab dipped in 90% isopropyl alcohol. Allow the solvent to evaporate.
  8. When the solvent has evaporated, soak a clean swab in a general-purpose, higher-viscosity silicone or PTFE oil lubricant.
  9. Apply an even layer along all exposed surfaces of both cutter blades. Remove any excess oil so that none of it comes in contact with the printhead or platen roller.
    The cutter blade is sharp. For operator safety, replace the cutter shield.
  10. Replace the cutter shield and secure it with the thumbscrew and lock washer that you removed earlier.
  11. Close the media cover.
    Close the media cover with the tear option
  12. Plug the printer into its power source, and then turn on (I) the printer.
    The cutter blade returns to its operating position.
  13. If the cutter continues to perform unsatisfactorily, contact an authorized service technician.