1. SC-2000 Stand Installation Guide
  2. Assembling the Dual Monitor Countertop Stand
  • SC-2000
Assembling the Dual Monitor Countertop Stand

Assembling the Dual Monitor Countertop Stand

This section describes the Dual Monitor Countertop SC-2000 assembly process.
  1. Use a flathead screwdriver to remove the vertical stand cover (1) and top cover (2). Set them aside.
    Removal tool shown disengaging the vertical cover from the stand.
    Removal tool disengaging the top cover from the stand.
  2. Route all cables through the center hole at the bottom of the vertical stand.
    DC line running up through the vertical stand body.
  3. Place the vertical stand body on top of the base.
    Vertical stand lowering onto the base.
  4. Use the provided Allen key to tighten the three bolts to secure the vertical stand body to the base.
    Allen wrench tightening screws to base.
  5. Pull the cables up through the vertical stand body, and then push them through the slot on the front of the VESA mounting plate.
    DC cable pulling up through the stand's VESA plate.
  6. Pull enough cable through so that it sits on top of the VESA plate.
  7. Route the USB-C to USB-C Power cable through the front slot of the VESA plate through the top of the stand, and through the second VESA plate slot.
    USB-C cable running from one VESA plate face through the other.