1. SC-2000 Stand Installation Guide
  2. Assembling the Single Monitor Countertop Stand
  • SC-2000
Assembling the Single Monitor Countertop Stand

Assembling the Single Monitor Countertop Stand

This section describes the Single Monitor Countertop SC-2000 assembly process.
  1. Use a flathead screwdriver to remove the vertical stand cover and set it aside.
    Removal tool shown disengaging the vertical cover from the stand. MC18 tool removing the top cover from the stand.
  2. Route the DC power cable through the center hole at the bottom of the vertical stand body.
    DC line running up through the vertical stand body.
  3. Place the vertical stand body on top of the base.
    Vertical stand lowering onto the base.
  4. Use the provided Allen key to tighten the three bolts to secure the vertical stand body to the base.
    Allen wrench tightening screws to base.
  5. Pull the cables up through the vertical stand body, and then push it through the slot on the front of the VESA mounting plate.
    DC cable pulling up through the stand's VESA plate.
  6. Pull enough cable through so that it sits on top of the VESA plate.