This section describes mounting the TD50 to the stand.
Place the TD50 screen side down on a soft cloth.
Leave the protective film on the device (if present) until the device is mounted and ready to use.
Use the Allen key provided with the TD50 to loosely screw the top two screws (M4x8 mm) provided into the 100 mm (3.94 in.) frame on the back of the TD50.
Connect the USB-C cable to the port to power the device.
The TD50 screen will not turn on if the USB-C cable is connected to the wrong port. Ensure the cable is connected to the DP port.
Create a loop of the cable and press it down into the vertical body of the stand.
Hang the TD50 on the VESA plate by sliding the two screws into the VESA screw slots.
As you bring the TD50 closer to the stand, pull the excess cable down into the vertical stand body by pressing on the loop you created in Step 4.
Rotate the VESA plate up to improve access to the bottom of the TD50.
Loosely attach the two bottom M4x8 mm screws on the bottom of the VESA plate.
Check that the cables are still securely connected.
Use the Allen key provided with the TD50 to tighten all four screws to secure it to the stand.
(Optional) Use the Allen key to adjust the two tension screws to increase or decrease the ease with which the VESA plate rotates.
Replace the KC50 back covers and stand covers to complete the assembly process.
port to power the device.
