Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
Resonate RFID Reader Management Installation Guide
Installing the Software
Adding a Node
Resonate RFID Reader Management 2.0 Software Installation Guide
Resonate RFID Reader Management 2.0 Software Installation Guide
About this Guide
Icon Conventions
Notational Conventions
Introduction
Overview
Network Architecture and Integration of Resonate RFID Reader Management
Integrating Into Your Asset-Tracking Solution
Kubernetes Environment
Preparing for Installation
Server Preparation Overview
System Requirements
Access to the Zebra Artifactory Repository
Creating a Zebra SSO Account
Creating an Identity Token
Prerequisite Software
Configuring the Machines
MicroK8s Multi-Node Firewall Documentation
Installing the Software
Resonate Software Installation Overview
Single-Node Configuration: Setting Up and Installing
Multi-Node Configuration: Setting up and Installing
Starting Resonate RFID Reader Management
Resonate RFID Reader Management User Interface
Resonate Device Initializer and Initializing the RFID Readers
Adding a Node
Removing a Node
Keycloak and Using a SMTP Server with Custom CA
Adding the Certificate to Keycloak
Configuring the SMTP Settings in Keycloak
Installation Scripts
setup.sh
install.sh
Validation
System Validation
Validating That Resonate Is Operational
Troubleshooting
Kubernetes
Generic Troubleshooting Commands
Kubernetes Status
Troubleshooting Kubernetes
Resolving Storage Failures
Troubleshooting Network Flow
Following Request Logs
Adding a Node
Adding a Node
Without reinstalling Resonate RFID Reader Management, you can add a machine (node) to a multi-node configuration (cluster).
You cannot add a node to a single-node cluster.
Follow the instructions in the
Secondary Nodes - Setup
section of
Multi-Node Configuration: Setting up and Installing
.
Only perform the steps for the node that you are adding. Ensure to run the
--finalize
step from the primary node at the end.
Installing the Software
×
