Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
Resonate RFID Reader Management 2.1 Installation Guide
Introduction
Getting Help
Resonate RFID Reader Management 2.1 Software Installation Guide
Resonate RFID Reader Management 2.1 Software Installation Guide
About this Guide
Icon Conventions
Notational Conventions
Introduction
Overview
Network Architecture and Integration of Resonate RFID Reader Management
Integrating Into Your Asset-Tracking Solution
Kubernetes Environment
Getting Help
Preparing for Installation
Server Preparation Overview
System Requirements
Access to the Zebra Artifactory Repository
Creating a Zebra SSO Account
Creating an Identity Token
Prerequisite Software
Configuring the Machines
MicroK8s Multi-Node Firewall Documentation
Installing the Software
Resonate Installation Overview
Setting Up a Single-Node Cluster
Setting Up a Multi-Node Cluster
Installing Resonate RFID Reader Management
Starting Resonate RFID Reader Management
Resonate RFID Reader Management User Interface
Resonate Device Initializer and Initializing the RFID Readers
Adding a Node
Removing a Node
Keycloak and Using a SMTP Server with Custom CA
Adding the Certificate to Keycloak
Configuring the SMTP Settings in Keycloak
Upgrading the Software
Before Starting the Upgrade Process
Performing the Upgrade
Validation
System Validation
Validating That Resonate Is Operational
Troubleshooting
Kubernetes
Generic Troubleshooting Commands
Kubernetes Status
Troubleshooting Kubernetes
Resolving Storage Failures
Troubleshooting Network Flow
Following Request Logs
Troubleshooting a Manual Setup
Installation Scripts
setup.sh
install.sh
Manually Setting Up a Resonate Kubernetes Cluster
Manually Setting Up Overview
Updating and Preparing the System
Installing snapd
Installing MicroK8s
Configuring Kubernetes
Joining the Nodes into a Cluster
Setting Up Single-Node Storage
Setting Up Multi-Node Storage
Creating the Resonate User trif-user
Finalizing the Setup
Getting Help
Getting Help
If you encounter issues not covered in this guide and are a registered user, follow the steps outlined below.
Record the steps you took and any error messages.
Gather system information:
sudo microk8s inspect > microk8s-inspect.log sudo journalctl -u snapd > snapd.log
Contact Zebra support with the log files
Introduction
×
