Flying Leads Color (24 AWG) | Function | 12-Pin A-Coded Male M12 to FS80 | 8-Pin A-Coded Female M12 to ZIML | ||
|---|---|---|---|---|---|
Green
Green must be connected to -VDC to operate the Zebra Integrated Multifunction Light. | OUT_COMMON | 1 | Green | 6 | Green |
Brown | N/A | 2 | Brown | - | |
Yellow | OUT2 | 3 | Yellow | - | |
Red | +VDC | 4 | Red | 1 | Red |
Grey | IN3 | 5 | Grey | - | |
White/Violet | IN_COMMON | 6 | White/Violet | - | |
Violet | IN5 | 7 | Violet | - | |
White/Yellow | IN6 | 8 | White/Yellow | - | |
White/Brown | IN4 | 9 | White/Brown | - | |
Black | -VDC | 11 | Black | 8 | Black |
Orange | PASS | - | - | 7 | White/Orange |
Blue | FAIL | - | - | 2 | White/Blue |
White/Green | RESERVED_PROG | - | 3 | White/Green | |
Flying Leads Color (24 AWG) | Function | 12-Pin A-Coded Male M12 to FS42 | 8-Pin A-Coded Female M12 to ZIML | ||
|---|---|---|---|---|---|
Yellow | GPIO2 | 1 | Yellow | - | - |
White/Yellow | TXD | 2 | White/Yellow | - | - |
Brown | RXD | 3 | Brown | - | - |
- | GPIO4 | 4 | Orange | 4 | Orange |
- | GPIO5 | 5 | Blue | 5 | Blue |
White/Violet | COMMON_IN | 6 | White/Violet | - | - |
Red | DC_IN | 7 | Red | 1 | Red |
Black | GND | 8 | Black | 8 | Black |
Green | COMMON_OUT | 9 | Green | 6 | Green |
White/Brown | GPIO0 | 10 | White/Brown | - | - |
Violet | GPIO1 | 11 | Violet | - | - |
Grey | GPIO3 | 12 | Grey | - | - |
Orange | PASS_OUT | - | - | 7 | White/Orange |
Blue | FAIL_OUT | - | - | 2 | White/Blue |
White/Green | RESERVED_PROG | - | - | 3 | White/Green |
Pin | Signal | Description |
|---|---|---|
1 | VDC+ | The positive power terminal (24V relative to VDC-) |
2 | FAIL_OUT | The pulse output from the light that is triggered when a FAIL command is sent on CONFIG_IN (+24V relative to COMMON_OUT). |
3 | RESERVED_PROG | This is reserved for use with a Zebra ZIML firmware update tool (connect to VDC- or leave unconnected). |
4 | STROBE_IN | The strobe pulse input to the light (+24V relative to COMMON_OUT). |
5 | CONFIG_IN | The command/configuration pulse input to the light (+24V relative to COMMON_OUT) |
6 | COMMON_OUT | The low side reference for the light's output signals. |
7 | PASS_OUT | The pulse output from the light that is triggered when a PASS command is sent on CONFIG_IN (+24V relative to COMMON_OUT) |
8 | VDC- | Negative power terminal. |
