Solutions
Hardware
Software
Services
Support and Downloads
About Zebra
PS30 Quick Start Guide
Installing the USB Programming Cable
PS30 Quick Start Guide
PS30 Quick Start Guide
Unpacking the Device
Device Features
Installing the Battery
Replacing the Battery
Charging the Device
Imaging and Charging Indicators
Accessories for Charging
1-Slot Cradle
3-Slot Cradle
Releasing the Device from Locking Charging Cradles
Software Release Using the Menu
Software Release Using the Cradle Utility
Manual Release Using a Release Key
Manual Release from the 1-Slot Cradle
Manual Release from the 3-Slot Cradle
Installing the USB Programming Cable
Removing the USB Programming Cable
Soft Holster
Using the Belt Clip
Using the Shoulder Strap
Scanning Barcodes
Ergonomic Considerations
Installing the USB Programming Cable
Installing the USB Programming Cable
Use the USB programming cable to program and charge the PS30 personal shopper. This section provides instructions for installing the cable.
Touch and hold the scan key to wake the device.
Touch and hold
.
Touch
Power off
.
Remove the standard battery cover that comes installed on the device, if it is not already removed.
Using a Phillips (PH00) screwdriver, loosen the captive screw that secures the battery cover.
Rotate the battery cover up, and remove it from the handle.
Slide the tab at the top of the battery cover with the USB programming cable into the slot on the back of the device.
Push the bottom of the cover down until it snaps into place.